Plumbing problems are common in many households. Sluggish sinks, leaking faucets and the toilet that just won’t flush happen to everyone from time to time. Plumbing issues can be embarrassing and problematic, especially if you let them go and don’t take care of them.
Whereas some of them can only be fixed by professionals, some common challenges can be fixed quite easily with a little know how. Taking early action on clogs, drips, and leaks is critical in preventing serious damage such as collapsed drains and overflows; fixing plumbing issues yourself, can save you a lot of money every year.
Here are the top 3 plumbing challenges you can fix on your own.
A slow draining sink is probably the most common plumbing challenge in many homes. The hair, gunk, soap and dead skin that accumulate inside your bathroom sink can cause it to drain very slowly. It is important to get the drain flowing again immediately to avert further problems.
To do this, you will need to clean out the drain. Get a screwdriver and a coat hanger. Unscrew the stopper and pull out any visible obstruction using the coat hanger. Rinse the sink drain with running water and replace the stopper. These easy steps will solve the problem and prevent the drain from clogging up completely.
The sound of a leaking faucet can be annoying. Not to mention the gallons of water that waste away down the drain. Fixing a leaky faucet is so easy, you can do it yourself. To fix your problematic tap, you will need pliers, a drain plug, new washers, and gloves. Check where the leak is coming from and shut off the water supply.
Carefully disassemble the faucet and place a stopper on the drain to ensure that you do not lose the small parts. Replace the damaged and worn out washers and reassemble the faucet. Turn on the water supply and allow water to run until all the trapped air is out of the pipes. Your faucet will be as good as new in an hour or less.
A constantly running toilet can inflate your bill and cause a permanent mess in your toilet. A damp floor is the perfect breeding ground for harmful bacteria and mold. Luckily, fixing a running toilet is easy and you do not require any tools or a plumber to get it done.
Start by identifying the cause of the running toilet. Remove the toilet lid and carefully place it at a safe corner. Locate the flapper chain and adjust it. If the toilet still runs after the adjustment, then it could be that the flapper is worn out and needs to be replaced. Remove the flapper and replace it with an exact match from the hardware. Flush your toilet and check if the problem is solved.
If the toilet continues to run, check if the toilet fill valve is the problem. Shut off the water supply and flush the toilet so that the tank is empty. Wipe off all the water and ensure that the tank is dry. Remove the old fill valve and replace it with a new one. Turn on the water supply and flush the toilet. This should sort out the problem.
There you go. 3 plumbing challenges you can fix on your own. If you run into a problem while fixing these issues, Diamondback Plumbing The Plumbing Professionals are a phone call away. With 24-hour emergency services and experienced technicians, your plumbing will be fixed fast and easy.